USB Cable Tester board, power supply, cable, and 47 similar items

USB CABLE TESTER with optional power supply and cable Includes 1 AMp USB charger and USB-A to USB-C power cable. See my other auctions for the tester alone. This little bare circuit board allows you to test the following types of USB cables: USB-A (male) to USB-C (male) USB-A (male) to Apple Lightning (male) USB-A (male) to micro USB (male) USB-C (male) to USB-C (male) (basic 5 pin mode) USB-C (male) to Apple Lightning (male) USB-C (male) to micro USB (male) It will indicate continuity of Power +, Power -, Data +, Data -, and CC (for USB C only). This deluxe bundle version includes the following: 1) USB tester 2) Basic USB-A Charger, 1 Amp or greater. UL and FCC certified for safety and interference. 2) High quality flexible cloth USB-A to USB-C cable with power LED (to power the tester). 3 foot long, color may vary. 3) Instructions Buyer must provide the following items to use this tester (not included): * One or more cables to test. You can buy these from other vendors. However, in my experience, as many as 10% of these boards do not work. I test each one and also include a detailed instruction sheet. Flat rate shipping (50 states and DC) includes a mandatory Bonanza shipping fine of $2 (if they stop stealing from sellers I will remove that surcharge). Instructions: UD11A03 USB Tester Instructions Using a suitable cable (USB-A to USB-C), included, connect your 5 Volt USB power supply*, not included, to the Power-IN connector jack. Connect the cable to be tested to the suitable jacks, with one end connected to the top of the of the tester, and the other end to the jack at the bottom (see below for cables that can be tested). Observe the red LEDs in the center of the board. For Apple and USB-C connectors remove, flip, and retest. Both positions should work. The results can be interpreted according to table 1. NOTES: -Flex the cable during the test. If LEDs flicker, the cable is bad. -Charge-only cables are particularly useful in airports, hotels, and other public spaces where available chargers may provide a data security risk. -If the LEDs are dimmer on certain cables that could be an indication resistance is unusually high. Consider resistance testing of the subject cable. *A USB-A power supply is strongly recommended. Most USB-C power supplies will not work. Instructions Copyright 2023 Rolf Taylor IMPORTANT STUFF (please read before bidding): I strive for satisfaction. Please read the following to give you realistic expectations as to what I can do for you. Unless otherwise stated, I offer flat rate shipping. Please take the shipping amount into account when bidding - this allows you to know exactly how much you will be paying for the item in total. I accept Paypal ONLY. I ship to the Paypal verified address ONLY. I ship USPS unless you contact me prior to bidding, and I agree to do otherwise (this will likely delay shipment). For this item I will accept returns. Seller pays shipping in both directions. No shipments outside the 50 states (and DC) of the USA. ONLY exception: If you are on a US military base outside the 50 states contact me with shipping address IN ADVANCE of the auction closing, and I will see if I can do it. In this case the quoted flat rate shipping will not apply. I will bill you the exact USPS charges. I do not ship every day. I ship USPS at least twice a week. So it may take up to 4 days for your order to ship. I usually do better. If you need an item quickly contact me BEFORE bidding for possible other shipping options (flat rate shipping will not apply). If you have negative feedback please don’t bid. Your bid will be canceled. If you will not be paying within 72 hours let me know so there will be no unexpected problem with your feedback. I do not want to give you negative feedback. If you have ANY questions or problems please contact me BEFORE leaving feedback. Please give me the chance to make things right!