Order 4 or more connectors and receive a roll of Nashua wire harness tape FREE. Genuine Ford Motorcraft. Arrives fully assembled and ready for installation. Picture showing the connector taken apart is to demonstrate all of the included components as specified by Ford. I have also included a connector diagram from the Ford Factory Service Manual for reference. INCLUDES: 3 wire terminals Housing (20% glass reinforced) Grommet cap PLR (Primary Lock Reinforcement) CPA (Connector Position Assurance device) Matte seal Interfacial seal ELECTRICAL SPECIFICATIONS: Voltage: 250V Current: 22.0A Contact Resistance: 10 milliohms max. Dielectric Withstanding Voltage: 500V DC Insulation Resistance: 20 Megohms min. You will want to reuse your factory original wiring and terminals. 1. Simply remove the wire/terminal assemblies from the old connector (feel free to break it apart as you have new ones! Just be careful to not damage your wire/terminals). 2. Do note the position of each wire in relation to the connector. 3. Insert the wire/terminals into the new connector. You should hear an audible click. 4. From the front of the connector, push the white PLR inward to lock the terminals in place. 5. Install connector on coil. 6. Push the red CPA forward to lock the connector in place. 7. Rinse and repeat with each connector. 8. Done. Applications: FORD EDGE 2007-2019 FORD C-MAX 2013-2018 FORD EXPLORER 2011-2019 FORD EXPEDITION 2015-2019 FORD F-150 2010-2019 FORD F-250 SUPERDUTY 2011-2018 FORD F-350 SUPERDUTY 2011-2018 FORD FLEX 2009-2018 FORD FUSION 2010-2019 FORD MUSTANG 2011-2019 FORD POLICE INTERCEPTOR SEDAN 2013-2018 FORD POLICE INTERCEPTOR UTILITY 2013-2018 FORD RANGER 2019 FORD TAURUS 2008-2019 FORD TAURUS X 2008-2009 FORD TRANSIT 150, 250 and 350 2015-2019 LINCOLN CONTINENTAL 2017-2019 LINCOLN MKC 2015-2018 LINCOLN MKS 2009-2016 LINCOLN MKT 2010-2017 LINCOLN MKX 2007-2017 LINCOLN MKZ 2007-2019 LINCOLN NAVIGATOR 2015-2019 MAZDA 6 2009-2013 MAZDA CX-9 2007-2015 MERCURY SABLE 2008-2009