125KHz RFID Card Cloner, Includes a Free ID RFID Thick Card and Keyfob - 125kHz Low-Frequency HID-Compatible Access Control Card with 26-Bit Wiegand Format. - Compliant with ISO 1386/1326/H10301 Standards. Supported Card Formats - EM4100, HID (Low Frequency), AWID Specifications - Frequency: 125KHz - Power Supply: 2 x AAA batteries (supports up to 20,000 uses) - Reading Distance: - Keyfob: 25mm - Card: 60mm - Device Dimensions: 71 x 117 x 31 mm - Supported Blank Tags: T5577, EM4305 Key Features - Effortlessly clones EM4100, HID, and AWID RFID cards. - Compact, portable design powered by standard AAA batteries. - Fully compatible with 125kHz low-frequency RFID cards and keyfobs. - Includes: - A free ID RFID Thick Card (HID-compatible, 26-bit Wiegand format). - A keyfob compliant with ISO 1386/1326/H10301 standards. - Limitations: Cannot clone HID Indala cards. How to Use the Device # 1. Power On the Device - Slide the power switch on the right side of the device. - Upon powering on, the device will beep: - 3 beeps: Device is ready for EM4100, HID, and AWID cards. - The LED indicator will light up, confirming the device is ready to use. # 2. Reading the Source Card 1. Place the source card (mother card) near the left-side antenna. 2. Press the READ button: - Successful Read: The device will beep, and the LED will light up. - Beep twice: Proceed to Step 3. - Beep three times: Proceed to Step 4. # 3. Writing to Blank Tags - Use a compatible blank tag: T5577 or EM4305. For EM4100 or HID Cards: 1. Replace the source card with a blank tag. 2. Press the WRITE button: - Successful Write: The device will beep, and the PASS LED will light up. - Unsuccessful Write: Retry the process. For AWID Cards: 1. Replace the source card with a T5577 blank tag. 2. Press the WRITE button: - Successful Write: The device will beep, and the PASS LED will light up. - Unsuccessful Write: Retry the process. # 4. Creating Additional Clones - Repeat Steps 2 and 3 to create more duplicates of the same source card. # 5. Power Off the Device - Slide the power switch to OFF to save battery power. Warnings and Notes - HID Indala cards are not supported. - If the device does not beep or light up, restart and repeat the process. - Ensure the blank tags used are compatible with supported formats (T5577 or EM4305).