Description in this listing you are bidding on two 3D printed front doors for the Tomy Giant Thomas. I will print them in red but it probably will not match the original red. However you can paint them to match. I will also include two black buffers. The buffers will need to be screwed into their positions (screws not included) or You may be able to glue them on. Please be sure to check the measurements to be sure that you have the correct giant Thomas. This particular giant Thomas is made to be part of a tunnel and also storage for trains. Installation When installing these I usually put the bottom hinge pin into the bottom hole then push the top one into place once both doors are into their locations I close them both together so that they close tightly. These items are not for children as the buffers could be swallowed. Adult supervision required.