Acid Tactical Camouflage Stencil Set - 2 Layer Design VIETNAM TIGERSTRIPE 9x14" Sheets - Read product description for full details. 2 stencils as shown in our main image. Designed for use on Rifles, Shotguns, Pistols. Can be used on Plastic, Metal, Wood, etc.. .25mm Vinyl Sheets - Peel off, stick on Stencils) Can be used with all types of paints including, Rattle can, Duracoat, Cerakote, water, and oil based paints. This is a Vietnam Tigerstripe two layer set. The smaller patterns are layer 1, layer 2 are the 4 large patterns. Acid Tactical ADHESIVE camo stencils. Our stencils will not leave sticky glue residue behind. They were designed to remove cleanly and not effect the paint. Stencils are heat resistant on both metal and polymers. They do not shrink on ABS and Polymers when flash curing like the yellow avery paper. They leave little to no adhesive behind so no messy clean up. What you get. 2 - 9x14" stencils - 1 of each pattern. Specifications: Material: High Temp Vinyl film Thickness: .25mm Length: 14" Width: 9" For angled surfaces: When shaping around corners use larger stickers and allow half of the sticker to lay on each plane. If small sections of the design overlaps a corner it may not adhere well. Use scissors to trim any excess that doesn't want to adhere. Useful Tools: Exacto knife - Can be used to remove sticker and also to form sticker in tight angles. Scissors - To trim excess stencil STENCILING STEPS: 1. Basecoat your project with a good camouflage color. 2. Clean off the project to remove any dust or paint residue. Be sure to have clean hands and refrain from touching the adhesive side during application. 3. Apply the stickers to your project. Using a shar Additional Details ------------------------------ Package quantity: 1