Depending on the size of your project please consider purchasing more than one product. How to use this concrete paver mold to establish the path: Step 1: Mix the cement with water according to the packing instructions. When ready for use, the concrete will be the consistency of the oatmeal and thick enough to hold the edges when cut with a shovel. Step 2: Fill the paver mold, plow the concrete with a shovel and make sure to fill each area. Step 3: Using rubber gloves, place the concrete around the mold and fill any gaps or low points. Tap the mold by hand to remove any air bubbles. Step 4: Smooth the concrete according to the contour of the mold and wipe off the excess. Step 5: Allow the concrete to set up for a maximum of five minutes, then carefully remove the mold. For the next stretch, rotate the mold a quarter turn and place it next to the paver you just finished. If you are creating a curved path, tilt it slightly. Step 6: After curing the concrete overnight, fill the crack with dirt and rinse off the excess. Wet the ground around the newly formed paver to help them settle Package Included: 1 x concrete slab path mould