ONE good used Samsung AFS145ZUEA motor looks to cross to GE WJ94X10110 These are impossible to find right now, seem to run around $275 new, but everyone seems to be out of stock. This one came out of an air conditioner (240vac) that ran fine except its compressor quit. Fans were verified working fine when removed. Ran smooth no wobbles or anything abnormal (assuming your blades are in balance) . Note the shaft ends and connector. (you may need to rewire if yours has a different connector, see pict with schematic /color code) Note about the threads on end of shafts: the short shaft is reverse thread (backwards spin) and odd nut is included as shown, and threads are fine on shaft and nut on the longer shaft (normal direction threads) the nut looks to have been cross threaded or bound up when getting on or off. It was tight to get off, but does spin back on, but as you can see in picture looks "buggered" at a few of end threads. We would recommend reusing the nut off your old shaft , or get a new one (standard Metric one) then rock it back and forth as you tighten it, to clean threads or use a dye on the end first to clean the threads if it feels like it will bind. Or you can just tighten it down the way it is and it will probably be fine but selling as you see it and wanted to point that out. long shaft length is approx 6.5" from bearing short shaft length is approx 3 1/4" from bearing end to end approx 14" (36cm) square flange/ mount is approx 6x6" ONLY WHAT IS SHOWN IS INCLUDED schematic/color code not included, you can print out or take a picture of our picture in this listing. Guaranteed working on arrival to buyers with proper knowledge. NEED IT FAST ? JUST ASK, DEPENDING ON OUR SCHEDULE, WE MAY BE ABLE TO SHIP OUT PRIORITY, SAME DAY OR NEXT DAY (We put in a 3 day handling time but often can ship faster Just ask first to verify)