Toilet Seat Hinges Kit And 4 Pieces Toilet Seat Bumpers For Kohler, Toilet Cover TOILTOBLE Toilet Seat Parts Replacement Product Description Note: This Hinge Kit is suitable for KOHLER 1150464-0/1109093-0 toilets seat part. They hold the toilet seat in place. Please confirm the size before buy it. Specification: - Packing including?1 x Hinge Assembly;1 x Bottom Cover;2 x hinge cover;2 x hinge Mount;2 x Damper Amortisseur Amortiguador; 4 x Toilet Seat Bumpers - Material: plastic; Rubber - Color: white - Size: 7 inches in total length, 0.36 inches in thread diameter. Installation: 1. Remove the toilet seat in the closed position from the toilet. 2. Lay the toilet seat on a flat surface with the hinge assembly toward you, as shown. 3. Place your thumbs over the slots of the hinge assembly, then pull up on the bottom cover for removal. 4. Using a needle nose plier, pull each damper inward to release the hinge assembly from the toilet seat. 5. Discard the hinge assembly. 6. Reinstall the dampers to the new hinge assembly. Ensure the right and left dampers (stamped on the end of each damper) correspond with the left and right hinge (stamped L and R) of the hinge assembly. 7. Set the hinge assembly in place with the hinge covers facing toward you. 8. Push the dampers outward to secure the hinge assembly to the toilet seat. 9. Snap the bottom cover of the hinge assembly back into place. 10. Reinstall the toilet seat to the toilet. Package including: 1 x Hinge Assembly;1 x Bottom Cover;2 x hinge cover;2 x hinge Mount;2 x Damper Amortisseur Amortiguador; 4 x Toilet Seat Bumpers Suitable for: This part can replacing your toilet broken part, make your toilet seat Quiet close lid closes slowly and quietly without slamming?Engineered to promote product longevity. It is compatible with Kohler 1150464-0/1109093-0 Hinge Kit High Quality Material: Use durable ABS plastic,will not deform over time, make sure they are sturdy enough to handle daily use, and provide cushioning and protection for your toilet seat Toilet Seat Bumpers Size: The toilet seat bumper length is 1.37 inch/45mm, width is 0.39 inch/10mm and the thickness is 0.39 inch/10mm. Whether it is an elongated or round toilet seat, it can be used as long as the size is the same Note: Please measure the size of your original part to match our products before purchasing. This will prevent you from receiving unsuitable products and experiencing longer repair times. If you have any questions with this product, please contact us immediately